3GPP TS 27.007 V6.3.0 (2003-
06)
Annex A (normative):
Summary of commands from other standards
Summary of ITU-T Recommendation V.250 [14] commands applicable to GSM/UMTS:
Table A.1: V.250 commands applicable to GSM/UMTS
Subclauses in the
present document
Circuit 109 (Received line signal detector) Behaviour
Circuit 108 (Data terminal ready) Behaviour
Set to Factory-defined Configuration
Data Compression Reporting
Request Complete Capabilities List
Request Manufacturer Identification
Request Model Identification
Request Revision Identification
Request Global Object Identification
Request Product Serial Number Identification
DTE-DCE Character Framing
DTE-DCE Local Flow Control
DTE-DCE Local Rate Reporting
Request Identification Information
Return to Online Data State
Automatic Disconnect Delay
Command Line Termination Character
Response Formatting Character
Command Line Editing Character
Pause Before Blind Dialling
Connection Completion Timeout
Result Code Selection and Call Progress Monitoring Control
Reset To Default Configuration
The use of ITU-T Recommendation V.42 error control protocol is not specified for GSM/UMTS, but if a manufacturer
chooses to implement it over transparent data service, +E prefixed commands of V.250 [14] shall be used.
ITU-T T.31 [11] and T.32 [12] may be used as facsimile TA-TE protocols without deletions or additions to the
command set.
TIA IS-99 [15] commands referenced in the present document:
Commentaires sur ces manuels